Buick ManageUPS Uživatelský manuál stáhnout pdf (Strana 54)

Appendix D: SNMP MIBS

ManageUPSNET User Instruction Manual 51

upsAlarm Group

(continued)

upsAlarmBypassBad Not applicable.

upsAlarmOutputOffAsRequested Conﬁrmation.

upsAlarmUpsOffAsRequested Conﬁrmation.

upsAlarmChargerFailed Battery charger has failed or its fuse has blown.

upsAlarmUpsOutputOff Conﬁrmation, persistent until output is turned on.

upsAlarmUpsSystemOff UPS shutdown.

upsAlarmFanFailure Not supported.

upsAlarmFuseFailure Input circuit breaker is open or charger fuse has blown.

upsAlarmGeneralFault A UPS fault was detected that is not speciﬁcally deﬁned in the

standard MIB.

upsAlarmDiagnosticTestFailed A user initiated test has failed.

upsAlarmCommunicationsLost Lost Serial Communications with the UPS.

upsAlarmAwaitingPower Not supported.

upsAlarmShutdownPending A shutdown timer has begun counting.

upsAlarmShutdownImminent Output shutdown will occur in approximately 5 seconds.

upsAlarmTestInProgress A user requested UPS test has begun.

upsTest Group

upsTestId SET this object to the Object Identiﬁer (OID) of the test you want to

run.

upsTestSpinLock In order to initiate a UPS test, you must use the upsTestSpinLock

as follows: First: GET (read) the current integer value of

upsTestSpinLock. Next: SET (write) the integer value just read

back to the upsTestSpinLock object and SET upsTestId to the OID

of the test you wish to run. It is required that the two SET

operations be performed in the same SNMP packet. The purpose

of the upsTestSpinLock object is to eliminate the possibility of two

Managers simultaneously initiating tests on the same Agent. See

the MIB description for more information.

upsTestResultsSummary All valid MIB results are supported. The result of the last test run

will be remain in this object.

upsTestResultsDetail If upsTestResultsSummary report doneWarning(2), doneError(3)

or aborted(4), then this object will contain a message string

detailing more information about the test failure.

upsTestStartTime The value of sysUpTime when the UPS test was initiated.

Table 7. RFC1628 Support (Continued)

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 66 67

Žádné komentáře

Buick ManageUPS Uživatelský manuál Strana 54