
Appendix E: RFC1213 and Generic Trap Support
ManageUPSNET User Instruction Manual 63
Generic Trap - PDU
Support
RFC1157 defines 7 Generic Trap-PDUs. The
following are applicable and supported by the
ONEAC SNMP Agent.
NOTE: Traps of any type will not be sent unless
a trap destination receiver(s) is configured
Table 10. Generic Trap -PDU Support
coldStart The following conditions cause this trap to be sent:
When power is applied to the interface. This occurs when the UPS is initially
plugged into AC power or when AC power returns when the UPS is not running.
Example: After the UPS has been shutdown to conserve the battery and later AC
power is restored.
NOTE: This is true, regardless of the position of the ON/OFF
switch on the UPS.
A Cold Start Trap is also sent whenever the agent is reset via software or the
RESET switch is pressed.
authenticationFailure This trap is sent when the interface receives a PDU with a community that does
not match any of the configured community(s) in the Agent.
NOTE: This trap is only sent if SNMP authentication traps
have been enabled.
Komentáře k této Příručce